We Fix It Right.

Diagnosed first
Most split system faults fall into a predictable set, and most of them get misdiagnosed when someone quotes a part before testing the system. We test airflow, pressures, electrical draw and drainage before recommending anything. That way you pay for the actual fault, not an educated guess.

01
| Symptom | Most likely cause | What we test |
|---|---|---|
| Running but not cooling | Low refrigerant from a leak, or a dirty condenser coil | Pressure test, coil condition and temperature differential |
| Ice on the indoor unit or pipes | Restricted airflow from a blocked filter or failing blower | Airflow measurement, filter condition, blower operation |
| Water leaking inside | Blocked condensate drain or a cracked drain pan | Drain flow, pan condition, unit level and pipe insulation |
| Loud rattle or grinding | Worn bearings, loose fan blade or debris in the housing | Fan assembly inspection and blade balance |
| Musty smell on start up | Mould in the drain pan or on the evaporator coil | Coil and pan inspection, drainage fall |
| Trips the safety switch | Compressor, capacitor or moisture in the electrics | Isolate, then component test and insulation resistance |
| Error code on the controller | Sensor, communication or inverter board fault | Code lookup against the brand chart, then circuit testing |
02
A system low on refrigerant has a leak, full stop. Recharging without finding it means the gas escapes again and you pay twice. We pressure test, locate the leak, repair it, then recharge to the manufacturer specification. That is the difference between a repair that lasts the season and one that lasts.
03
04
Filters and airflow, coil condition on both sides, refrigerant pressures and temperatures, electrical draw, capacitors and connections, condensate drainage, controller and sensors, and the outdoor unit clearances. You get the findings explained in plain English, including anything likely to fail next season, so you can plan rather than get caught.
Book a repair
For new systems, see split system installation. To stop the next fault, book split system maintenance once a year. Fault codes are covered in our error code library, and the full range sits under split system Sydney. Compare multi split systems and ducted systems, or start from air conditioning types. Everything else sits under air conditioning Sydney. We repair across Parramatta, Bondi and Blacktown.
The faults Sydney homeowners call us about most, and what is usually behind them.
The three usual suspects are low refrigerant from a leak, a dirty condenser coil, and restricted airflow from a blocked filter or failing blower. Each one produces the same symptom from the couch, which is why testing matters. We check pressures, coil condition and airflow before recommending a repair, so you are not paying for a part that was never the problem.