Positioning the indoor head
The head goes where the airflow works, not where the wall is easiest. We avoid blowing directly onto a bed or a couch, keep it clear of curtains, and check the unit is not fighting a heat source in the same room.
Done Right. First Time.

Sized for the room
Most split system complaints trace back to sizing and positioning, not the brand. We measure the room, check glazing, insulation and ceiling height, then calculate the load before recommending capacity. An oversized unit short cycles and never dehumidifies properly. An undersized one runs flat out and dies early. Getting this right on day one is the whole game.

01
| Your situation | System we would recommend | Why |
|---|---|---|
| One bedroom, study or small living area | Single split system | Lowest installed cost and the simplest job |
| Two or three rooms, one outdoor space | Multi split system | Several heads running from a single outdoor unit |
| Apartment or townhouse with tight balcony space | Multi split system | One condenser instead of several competing for space |
| Whole house, renovation or new build | Ducted system | Every room treated evenly, hardware hidden in the ceiling |
| Large open plan living with high ceilings | Higher capacity split or cassette | Standard wall units struggle to throw air across the volume |
02
03
The head goes where the airflow works, not where the wall is easiest. We avoid blowing directly onto a bed or a couch, keep it clear of curtains, and check the unit is not fighting a heat source in the same room.
Pipework is run with a continuous fall to the drain so condensate never sits in the line. Where the building allows, we conceal it in a duct or wall cavity. Where it does not, we run it neatly and tell you the route before we start.
The condenser needs airflow, service access and consideration for neighbours. We position it to meet clearance requirements and to keep noise away from bedroom windows and boundary lines.
We pull a vacuum, charge the system to specification, test in both modes and measure the temperature differential. Then we show you the controls and register the warranty.
04
Strata buildings usually require written approval before work starts, especially for anything visible from outside or fixed to common property. We can supply specifications and compliance details for your strata committee or building manager, which makes the approval process a lot faster than a vague request. For rentals, we can work around tenants and coordinate access.
Keep it efficient
Keep the unit efficient with split system maintenance once a year. If something is already misbehaving, start with split system repairs. Comparing options? See multi split systems and ducted systems, or the full split system Sydney range. All system types sit under air conditioning types, and everything else under air conditioning Sydney. We install across Bondi, Chatswood and Abbotsbury.
What Sydney homeowners ask us most before booking a split system install.
Cost depends on the capacity you need, how far the indoor and outdoor units sit apart, whether a new electrical circuit is required, and how difficult the wall or roof access is. A single split in a bedroom is a very different job to a head mounted on a double brick wall three metres up. We assess on site and give you a written quote before anything is ordered.